The Raspberry Pi Pico is a new microcontroller designed by the Raspberry Pi foundation. The Pico is a groundbreaking board that is meant to use MicroPython in its native micro USB port. The RP2040 is the microcontroller chip at the center of the Pico, which has a dual-core Arm Cortex M0+ processor, capable of clocking at 133 MHz, which is much faster than many of the Arduino boards currently on the market. The Pico has GPIO pins and interfaces such as: SPI, UART, I2C, PWM, and a 12-bit analog-to-digital converter (ADC). This Raspberry Pi Pico Kit comes with the Pico microcontroller, an RGB LED, a breadboard, jumper wires, and USB cable.

Included in the Raspberry Pi Pico Starter Kit:

• 1x Raspberry Pi Pico Board

• 2x 20-pin Headers

• 1x Black 0.5m Micro USB Cable

• 1x RGB LED

• 4x Male-to-Male Jumpers

• 1x Half Breadboard (White)

Features of the Raspberry Pi Pico:

• 1.8V - 5.5V Input Voltage

• 21 mm × 51 mm Board Geometry

• RP2040 microcontroller

• Dual-core Arm Cortex-M0+ processor (Clock Speed up to 133 MHz)

• 264KB on-chip SRAM, 2MB on-board QSPI Flash

• 26x GPIO pins (3x 12-bit Analog Inputs)

• 2x UART, 2x SPI, 2x I2C, 16x PWM

• 1x USB 1.1 controller and PHY, with host and device support

• 8x Programmable I/O (PIO) state machines for custom peripheral support

• Operating temperature -20°C to +85°C

• Low-power sleep and dormant modes

• Onboard Temperature sensor

• Accelerated integer and floating-point libraries on-chip

• Raspberry Pi Pico Datasheet, RP2040 Datasheet

NOTE: Our batch of RGB LED modules have reversed labels for green and red, meaning, the label R is for green, and G is for red. This was noticed after receiving and testing the modules from our manufacturer.